报错
Could not connect to Redis at 192.168.0.115:6379: Connection reset by peer
not connected>
(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.
192.168.0.115:6379> set a
此错误是因为windows上的redis-server启动的不对
一、下载解压redis，网址https://github.com/MicrosoftArchive/redis/releases，下载.zip压缩包。
二、解压到本地
三、修改redis.windows.conf，改完要再打开看看改没改过来。
1>注释掉bind #bind 127.0.0.1
2>默认不是守护进程方式运行，这里可以修改 daemonize no（一般设置为yes）
3>禁用保护模式protected-mode no
四、打开管理员命令提示行，进入解压后的目录。我的目录是E:\googledownload\redis\Redis-x64-3.2.100，执行命令redis-server redis.windows.conf，注意一定要加redis.windows.conf，否则连不上的
五、打开虚拟机
redis-cli -h +windows的ip地址
六、Windows上的redis远程连接Linux上的redis
可能会报错127471:C 22 Aug 21:39:39.798 # Fatal error, can't open config file '/etc/redis/redis/conf'，原因可能是你把redis.conf写成了redis/conf
